Connecting External SCSI Devices to Micro Webserver

Connecting Additional SCSI Drives to Micro Webserver

Micro Webserver is capable of reading and writing to devices with a valid, non-conflicting SCSI ID number. To connect additional devices:

Power off the Micro Webserver.
Switch SW1 on the rear panel to the down position.
Connect a SCSI cable to the SCSI cable port located on the rear panel of the Micro Webserver unit.
Attach the cable to your first SCSI CD-ROM drive. The last drive in the string requires a singled-ended SCSI terminator unless it is internally terminated.
Set the SCSI ID of the external devices.
Power on the Micro Webserver.

Setting the SCSI Device Drive IDs

Micro Webserver is the initiator in the SCSI string and uses ID-7. One to five SCSI CD-ROM drives are supported and they can be set as ID-0 or ID-2 through ID-6 (not ID-1 or ID-7) in any order in the string. Additionally, a SCSI drive of up to 1.2 GB can be accessed.

You are ready to use Micro Webserver. Refer to the chapter "Configuring Micro Webserver" to complete the configuration process.